Removing The Front-Bezel Heat-Sensor; Prerequisites; Procedure - Alienware Area-51 Service Manual

Removing the Front-bezel Heat-sensor

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before Working Inside Your
Working Inside Your
regulatory_compliance.

Prerequisites

1. Remove the stability foot.
2. Remove both the left and right side-panels. See
3. Remove the PCI fan. See

Procedure

NOTE: After removing the PCI fan, locate the sensor on the fan shroud.
1. Lay the computer on the left side.
2. Press the release tab on the securing clip.
3. Pry out the chassis heat-sensor cable from the securing clip.
4. Slide the chassis heat-sensor cable out of the bracket.
1. chassis heat-sensor cable
3. release tab
Computer. After working inside your computer, follow the instructions in
Computer. For more safety best practices, see the Regulatory Compliance home page at dell.com/
"Removing the Side
"Removing the PCI fan".
Panels".
2. securing clip
4. fan shroud
After
59