Table of Contents
Advertisement
Steps
1. Align the notch on the 2230 solid-state drive with the tab on the SSD slot two on the system board.
2. Insert the 2230 solid-state drive at a 45-degree angle into the system board.
3. Press the other end of the 2230 solid-state drive down and replace the screw (M2x3) that secures the 2230 solid-state drive to
the system board.
Next steps
1. Install the
left-side
cover.
2. Follow the procedure in
3. Verify if the storage device is installed correctly (optional):
a. If you are replacing a storage device which does not have the operating system installed, follow the steps in
storage device in device
b. If you are replacing a storage device which does not have the operating system installed, follow the steps in
storage device in system setup
Removing the 2280 solid-state drive in SSD slot two
Prerequisites
1. Follow the procedure in
2. Remove the
left-side
cover.
About this task
NOTE: This procedure applies only to computers shipped with a 2280 solid-state drive installed in SSD slot two.
The following images indicate the location of the 2280 solid-state drive that is installed in SSD slot two and provide a visual
representation of the removal procedure.
After working inside your
manager.
(BIOS).
Before working inside your
computer.
computer.
Identifying
Identifying your
49
Advertisement
Table of Contents
