Installing The Single-Graphics Card - Alienware Aurora R13 Service Manual

Steps
1. Lay the computer on the right side.
2. Lift the pull tab and open the expansion-card door.
3. Press the releasing clip on the graphics-card power connectors and disconnect the graphics-card power cables from the graphics
card.
4. Slide the release latch to its unlock position and lift the graphics-card end holder away from the PCIe fan.
5. Slide the release latch to its unlock position and lift the graphics-card bracket away from the graphics card.
6. Push the securing tab on the PCIe x16 slot down, grasp the graphics card by its top edge, and ease it out of the slot.

Installing the single-graphics card

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the single-graphics card and provide a visual representation of the installation
procedure.
42