Installing The Coin-Cell Battery; Memory Modules; Removing The Memory Modules - Alienware Aurora R13 Service Manual

Steps
1. Lay the computer on the right side.
2. Press the battery-release lever away from the coin-cell battery until the coin-cell battery pops up.
3. Lift the coin-cell battery out of its socket.

Installing the coin-cell battery

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the coin-cell battery and provide a visual representation of the installation procedure.
Steps
Insert the new coin-cell battery (CR2032) into the battery socket with the positive side facing up, and snap the battery into place.
Next steps
1. Install the left-side cover.
2. Follow the procedure in

Memory modules

Removing the memory modules

Prerequisites
1. Follow the procedure in
2. Remove the left-side cover.
38
After working inside your
Before working inside your
computer.
computer.