Installing The Antennas - Alienware Aurora R13 Service Manual

Installing the antennas

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the antennas and provide a visual representation of the installation procedure.
Steps
1. Place the antennas on the slots of the chassis and adhere the antennas to the chassis.
2. Align the screw holes and replace the two screws (M3x3) that secures the antennas to the chassis.
3. Route the antenna cables through the routing guides on the chassis.
4. Push the end of the antenna cables with the connectors to the wireless-card through the hole of the chassis.
5. Route the antenna cables through the routing clip inside the chassis.
Next steps
1. Install the front bezel.
2. Install the right-side cover.
3. Install the top cover.
4. Install the wireless card.
5. Install the left-side cover.
6. Follow the procedure in After working inside your computer.
65