Comm Led; Brightness And Speaker Buttons - Motorola VC70N0 Product Reference Manual

Charging LED Indicator (Continued)
Table 3-1
LED State
Slow Blinking Green
Solid Red

COMM LED

The COMM LED blinks to indicate WLAN radio activity.
COMM LED is enabled. To disable the COMM LED:
NOTE These settings are not persistent across a cold boot.
Tap
My Device icon
1.
RF Settings Tab Window
Figure 3-2
Tap the
2. Enable Comm Led
Tap .
3. OK
COMM LED Indicator
Table 3-2
LED State
Solid Green
Slow Blinking Green (once every 2
seconds)
Off

Brightness and Speaker Buttons

The Brightness button places the Quick Access Panel + (
where you can adjust the brightness of the display. The Speaker button places the Quick Access Panel + (
- ( buttons into the audio volume level mode where you can adjust the speaker volume level. See
P2)
Brightness on page 3-9
Backup battery is low (both external power and backup battery
available).
Back battery not available/Suspend state (external power only
available).
> icon >
Control Panel System Management
check box.
Excellent, very good or good RSSI signal strength.
Poor RSSI signal strength.
WLAN is OFF or not connected – no RSSI signal.
and
Adjusting the Volume on page 3-9
Indication
lists the states of the COMM LED. By default, the
Table 3-2
icon. The
System Management
Indication
and - ( buttons into the backlight control mode
P1) P2)
for more information.
Operating the VC70 3 - 3
window displays.
and
P1)
Adjusting the