Connecting A Serial Scanner (Rs457) To A Serial Port - Motorola VC70N0 Product Reference Manual

Set All Defaults Bar Code
Figure 2-39
NOTE The above allows the scanner to reset from any previous configuration to the default configuration.
Scan a SSI HOST barcode.
5.
SSI Host Bar Code
Figure 2-40
NOTE To select SSI as the host interface, scan the above bar code. This is a scan API mode SSI.
Scan Send Packeted Decode Data barcode.
6.
Send Packeted Decode Data Bar Code
Figure 2-41
Scan Write to Custom Defaults barcode.
7.
Custom Default Bar Code
Figure 2-42
Verify that the scanner is connected properly. See
8.

Connecting a Serial Scanner (RS457) to a Serial Port

NOTE Refer to the scanner Product Reference Guide for information on configuring the scanner.
To connect a serial scanner to the VC70:
Connect the serial scanner cable to the scanner.
1.
Connect the serial scanner cable to the COM1 port.
2.
Verifying the Scanner is Working Properly on page
Installation 2 - 29
2-42.