Setting Up A Scanner Using Data Wedge - Motorola VC70N0 Product Reference Manual

Scan a SPP Profile barcode to configure the scanner to Bluetooth SPP profile mode before the pairing.
3.
SPP Profile Bar Code
Figure 2-72
Scan Write to Custom Defaults barcode.
4.
Custom Default Bar Code
Figure 2-73
To pair the scanner with your VC70, scan the pair label barcode in the upper right side of the VC70.The
5.
scanner beeps indicating that it is successfully connected to the VC70.
Verify that the scanner is connected properly. See
6.
When completing scanning, scan the unpair label barcode in the upper left side of the VC70. This will
7.
disconnect your scanner from the VC70.

Setting up a Scanner Using Data Wedge

NOTE Data Wedge does not support scanners connected via a USB port.
To configure the VC70 to communicate with the scanner:
Double-tap the
1. DataWedge
Select
2. Advanced Configuration
Click until you return to
3. Back
Select
4. Input > Serial > <Required COM port> COM3 > Enable.
NOTE The above shown configuration is typical to one type of scanner. Configuration details per scanner type
are shown in
icon on the control panel to launch the application.
>
Profiles > Profile0 > Routs > Rout0 > Input > Plugin >
Profile0.
Table 2-1 on page 2-41.
Verifying the Scanner is Working Properly on page
Installation 2 - 39
2-42.
and select
Serial.