The Screen 屏幕 - PRESONUS Revelator io24 Owner's Manual

2
Connectionsand Controls
Front Panel
2.1
2.1.1 The Screen 屏幕
The screen displays metering, preset selection, and other important information.
The following information is displayed on Revelator io24's Home screen.
This is the default screen you'll see when you first use Revelator io24.
该屏幕显示测光、预置选择和其他重要信息。以下信息显示在 Revelator io24 的主屏幕
上。
这是您第一次使用Revelator io24时看到的默认屏幕。
6
10
48v 48v
7
1
1 2
9
1. Input Meters.These meters indicate the input level of the analog
inputs on your Revelator io24.Thered Clip indicatorwill light when
your input signal reaches -0.5 dBFS. At this level, the signal will begin
to overload the analog-to-digital converters and exhibit signs of
clipping. Use the gain controls to keep the signal below this level.
输入仪表。这些仪表显示您的 Revelator io24 的模拟输入的输入
电平。当您的输入信号达到-0.5dBFS时，红色的剪辑指示灯将亮
起。在这个电平上，信号将开始超过模数转换器的负荷，出现削
波的迹象。使用增益控制来保持信号低于这个电平。
2. Output Meters. These meters indicate the signal level received
from the first two driver returns (Main Left/Right). These meters
display the signal level before the main output level control.
输出仪表。这些仪表显示了从前两个驱动器返回（主左/右）
接收的信号电平。这些仪表显示的是主输出电平控制之前的
信号电平。
3. OutputVolume/Blend.This indicatesoutput volumeof
the currently-selected output (Headphones or Mains) just
like a volume knob—as well as Monitor Blend.
输出音量/融合，混合。这表示当前选择的输出（耳
机或主控）的输出音量，就像音量旋钮一样，也表示
监听混合。
4. Encoder status. Lets you know if the Encoder Knob is controlling Headphone
output level, Main output level, or monitor Blend (direct vs. hardware.)
编码器状态。让您知道编码器旋钮是否在控制耳机输出电平，主输出电
平，或监听混合（直接与硬件。）
5. USB Status indicator. Confirms that Revelator io24 is
connected via USB and functioning normally.
USB状态指示灯。确认Revelator io24通过 USB 连
5
0
3
3
12
2 4
2
4
L R
Revelator io24
Owner'sManual
8
12