PRESONUS Revelator io24 Owner's Manual page 19

2
Connectionsand Controls
Front Panel
2.1
The following information is displayed on Revelator io24's
Channel screens.Press Channel Select Buttons 1 or 2 to bring it
up. Press the Back button to return to the Home screen.
以下信息显示在Revelator io24的频道屏幕上。按频道选择
按钮1或2来调出它。按 "后退 "按钮返回到主屏幕。
2
0
5
3
+24dB
12
4
24
Fromthe Channel screen, the Encoder Knob can be
pressed to cycle through the following options:
在通道屏幕上，可以按编码器旋钮来循环浏览
以下选项：
1. Gain. Rotatethe Encoder to turn input Gain up or down. Usethis to
bring your connected instrumet or microphone signals up or down
to suitable recording levels. Avoid aforementioned clipping.
增益。转动编码器，将输入增益调高或调低。用它来使你连接的
仪器或麦克风信号上升或下降到合适的录音水平。避免前述的削
波。
2. High-pass filter 80Hz. Rotate the Encoder to turn the High-pass
filter on and off.This can be used to cut low-end rumble and
other unwanted low frequencies from your recordings.
高通滤波器80Hz。转动编码器来打开或关闭高通滤波器。
这可以用来减少录音中的低端隆隆声和其他不需要的低
频。
3. +48v Phantom Power. Rotate the Encoder to enable/disable
+48v power for attached condenser microphones.
+48v幻象电源。旋转编码器来启用/禁用连接电容式话筒的+48v电源。
Other information on the Channel screen includes:
通道屏幕上的其他信息包括：
4. InputMeter.Thismeterindicatestheinputleveloftheselected
channel onyour Revelatorio24, justlikeon theHome screen.
输入表。这个表显示您的 Revelator io24上所选通道的输
入电平，就像在主屏幕上一样。
5. Gainreductionmeter.Ifyou'rerunninganycompressionorlimiting
viaRevelatorio24'sDSP(DigitalSignalProcessing),theamountof
gain reduction being applied will be indicated by this blue meter.
增益降低表。如果您正在通过 Revelator io24 的 DSP（数字信
号处理）运行任何压缩或限制，正在应用的增益降低量将由这个
蓝色的仪表指示。
6
48v
3
1
80Hz
2
Revelator io24
Owner'sManual
14