PRESONUS Revelator io24 Owner's Manual page 95

7
AdvancedFeaturesandCustomizationTools
Advanced FatChannel andVoice Effects Controls
7.2
Tube Leveling Amplifier Tube 水准测量放大器
1. On/Off. Turns the Compressor on or off in the signal chain.
2. Gain. Sets input gain to the compressor. Because this type of
compressor operates in a different way than a standard compressor,
much of the way that it affects signals is based on the input
level. Try different settings to see what suits your needs.
3. Peak Reduction. Sets the amount of peak reduction to
apply to the signal.Higher settings resultin moregain
reduction and morepronouncedcompressioneffect.
4. Compressor/Limiter Toggle. The button below toggles the Tube Leveling
Amplifier between its compressor and limiter modes. When in compressor
mode,itacts withavariableratioof1:1-10:1.Wheninlimiter mode,it acts
with a variable ratio of 10:1-20:1, more aggressively limiting peaks.
5. Key Filter. This sets the frequency at which the Tube Leveling
Amplifierwillengage.Itwillstillprocesstheentirefrequencyrange,
but it is only engaged when the specified frequency is present.
6. Key Listen. Press to listen to the signal being used to trigger the compressor,
as set with the Key Filter control (including the effects of the high-pass
filter). Press again to switch back to the normal channel signal.
1.开/关。开启或关闭信号链中的压缩机。
2.获得。设置压缩机的输入增益。由于这类压缩机的工作方式与标准压缩机不同，它
对信号的影响在很大程度上是基于输入的
的水平。尝试不同的设置，看看什么适合你的需要。
3.峰值减少。设置应用于信号的峰值减少量。设置越高，增益减少越多，压缩效果越
明显。
4.压缩/限幅器切换。下面的按钮在压缩机和限制模式之间切换管调平放大器。在压缩
机模式下，以1:1 ~ 10:1的变比作用。在限幅模式下，它的作用比为10:1-20:1，具有
更强的限幅峰值。
5.关键的过滤器。这设置了管调平放大器将接合的频率。它仍然会处理整个频率范
围，但只有当指定的频率出现时才会使用。
6.关键听。按下听信号被用来触发压缩机，作为设置与关键滤波器控制 (包括高通滤
波器的影响)。再按一次，切换回正常的通道信号。
Revelator io24
Owner'sManual
90