Hearth and Home Technologies IntelliFire Touch IFT-RC400 Installation Instructions Manual page 5

b. Re-Pairing existing IFT-RC400 after add-
ing ACM, blower kit, light kit or powervent
Note: Whenever adding an accessory to an IFT
system, the ECM must be re-paired to
complete the installation.
1. Verify that all the wire connections are complete, and
verify that the ACM is powered by 120V.
2. On the IFT-ECM, move the ON/OFF/REMOTE switch to
the REMOTE position. The green LED will blink three
times. A few seconds later, an audible "beep" will occur
to indicate that the system is ready.
3. Locate the pairing hole on the IFT-ECM. See Figure 9.
Using a paper clip or similar item, press and release the
pairing button. The IFT-ECM will "beep" once and the
green LED blink for 14 seconds. During the 14 seconds, it
is normal for accessories such as lights or fan to energize
momentarily.
4. Touch the screen of the remote. As soon as the main
screen appears, tap on the gray indicator bar on the top
edge of the screen display. Next, immediately tap the
pairing icon as shown in Figure 10. Successful pairing
will be indicated by a double beep from the IFT-ECM.
Note: During re-pairing, some versions of the RC400
may display 'Now pairing remote to product'
before the being able to reach the diagnostic
menu on remote. This message will impair the
ability to access the pairing ICON button. See
Figure 8.
Figure 8 Pairing Remote
If the "Now pairing remote to product" icon occurs:
1. Verify that all the wire connections are complete, and
verify that the ACM is powered by 120V.
2. On the IFT-ECM, move the ON/OFF/REMOTE switch to
the REMOTE position. The green LED will blink three
times. A few seconds later, an audible "beep" will occur
to indicate that the system is ready.
3. Remove the battery cover and install three of the four AAA
batteries in the reomote control. Leave one of the batteries
out of the remote control. The fourth battery will be installed
during step 5.
5 Hearth & Home Technologies • IFT-RC400 & IFT-ACM Installation Instructions • 2326-982 Rev. Q • 4/21
4. Locate the pairing hole on the IFT-ECM. See Figure 8.
Using a paper clip or similar item, press and release the
pairing button. The IFT-ECM will "beep" once and the
green LED blink for 14 seconds. During the 14 seconds, it
is normal for accessories such as lights or fan to energize
momentarily.
5. After pressing and releasing the pairing button, quickly install
the battery into the RC400.
6. As soon as the main screen appears, tap on the gray
indicator bar on the top edge of the screen display. Next,
immediately tap the pairing icon as shown in Figure 10.
Successful pairing will be indicated by a double beep from
the IFT-ECM.
NOTICE: Only one IFT-RC400 remote control and one
IFT-RC150 wireless wall switch can be programmed into
an IFT-ECM. To program both an IFT-RC400 and an IFT-
RC150 to an IFT-ECM, repeat the same steps separately
for the IFT-RC400 and the IFT-RC150.
REMOTE POSITION REMOTE POSITION
GREEN LED GREEN LED
Figure 9 Pairing IFT-ECM
Figure 10 IFT-RC400 Wall Mount / Pairing Screen
PAIRING HOLE PAIRING HOLE