Hearth and Home Technologies IntelliFire Touch IFT-RC400 Installation Instructions Manual page 2

Figure 1 Connect IFT-RFM to IFT-ECM
4. Remove protective rubber cap from connector on the
top of the IFT-ECM. See Figure 2.
Figure 2 IFT-ECM
5. Attach velcro included with the IFT-ACM to the bottom
of the ACM. See Figure 3.
6. Connect the IFT-ACM to the IFT-ECM by aligning the
pins and tabs and pushing the IFT-ACM onto the IFT-
ECM until both tabs latch in place. Ensure the IFT-
ECM and IFT-ACM are aligned with each other and
fastened securely. See Figure 3.
Hearth & Home Technologies • IFT-RC400 & IFT-ACM Installation Instructions • 2326-982 Rev. Q • 4/21
'OFF' POSITION
Figure 3 Connecting IFT-ACM and IFT-ECM
WARNING! Risk of Shock! DO NOT touch male pins.
Leave rubber cap on all ports unless port is being con-
nected to an accessory kit.
LIGHTS LIGHTS
Figure 4 Fan, Lights and Power Vent Connection
7. The IFT-ACM can provide power to HHT approved kits
including fan, lights and power vent.
To connect a fan kit to the IFT-ACM, insert the
•
three prong male plug from the fan into the re-
ceptacle located on the right side of the IFT-ACM.
See Figure 4.
To connect a light kit to the IFT-ACM, remove pro-
•
tective rubber cap labeled 'LIGHTS' and connect
to the female cord that was supplied in your lights
kit into the three male pins on the IFT-ACM. See
Figure 4.
To connect a power vent kit to the IFT-ACM, re-
•
move protective rubber cap labeled 'AUX' and
connect to the female cord that was supplied in
your power vent kit into the three male pins on the
IFT-ACM. See Figure 4.
WARNING! Risk of Shock! DO NOT touch male pins.
Leave rubber cap on all ports unless port is being con-
nected to an accessory kit.
ATTACH VELCRO
POWER CORD POWER CORD
FAN FAN
POWER POWER
VENT VENT
2