Setup And Assembly; Shipping Contents - Jet JDP-15F Operating Instructions And Parts Manual

6.0 Setup and assembly

Read
assembly instructions
assembly. Failure to comply may cause serious
injury.
6.1 Unpacking
Separate all parts from the packing material. Check
each part against sect. 6.2 Shipping contents and
make certain that all items are accounted for before
discarding any packing material. Report any
shortages or shipping damage to your JET
distributor.
Exposed metal surfaces on the drill press have been
factory-coated with a protectant. Remove this with a
soft rag moistened with a light solvent, such as
®
kerosene or WD-40 . Do not use an abrasive pad,
and do not use gasoline, paint thinner or acetone –
these will damage plastic components and painted
surfaces.
After assembly, exposed metal surfaces on the drill
press should be periodically coated with a light
application of paste wax or other rust-protectant.

6.2 Shipping contents

Refer to Figures 2 and 3.
1 Head assembly – A
1 Table and bracket assembly – B
1 Table insert – C
1 Base – D
1 Column and foot assembly – E
1 Rack – F
1 Owner's manual (not shown)
1 Warranty card (not shown)
Hardware package (JDP17-HP2):
1 Drift Key – HP1
1 Table locking wrench 24mm – HP2
1 Handle, column lock – HP3
1 Handle, table elevating – HP4
3 Downfeed handles – HP5
1 Worm – HP6
3 Hex keys, 3/4/5/6mm – HP7
4 Socket head cap screws, M8x50 – HP8
4 Flat washers, 8mm – HP9
1 Chuck key – HP10
1 Chuck 5/8" – HP11
1 Arbor – HP12
6.3 Additional tools required for
assembly
(not provided)
Rubber mallet (or hammer and wood block)
13mm wrench (for table pin nut)
Cross-point (Phillips) screwdriver
and understand all
before attempting
Figure 2: Contents of shipping container
(JDP-15F column and rack shown)
Figure 3: Hardware Package (p/n JDP17-HP2)