Setup And Assembly; Unpacking And Cleanup - Jet JWJ-8HH Operating Instructions And Parts Manual

Setup and Assembly

Contents of Shipping Cartons
Note: Unit shipped in two cartons.
Stand Carton
1 Stand with Motor
1 Stand Door
1 Dust Chute with Mounting Hardware
1 Pedestal Switch with Mounting
Hardware (JWJ-8HH only)
Main Unit Carton
1 Bed Assembly
1 Fence Assembly
1 Cutterhead Guard
1 Belt Guard
2 V-Belts
2 Handwheels with handle
1 Fence Handle
3 Mounting Bolts
3 3/8" Lock Washers
1 Operating Instructions and Parts
Manual
1 Warranty Card
Tools Included with JWJ-8CS
1 12/14mm Open End Wrench
1 8/10mm Open End Wrench
3 Hex Wrenches (3, 4 and 5 mm)
1 Knife Gauge Assembly
Tools included with JWJ-8HH
1 12/14mm Open End Wrench
1 8/10mm Open End Wrench
4 Hex Wrenches (3, 4, 5, 6 mm)
2 Star Point Screwdrivers
5 Knife Inserts
10 Knife Insert Screws
Tools Required for Assembly:
#1 Cross Point Screwdriver
6-8" Adjustable Wrench or 17 & 19mm
Wrench

Unpacking and Cleanup

1. Carefully finish removing all contents
from both shipping cartons. Compare
contents of the shipping cartons with
the list of contents above. Place parts
on a protected surface.
2. Set packing material and shipping
cartons to the side. Do not discard until
machine has been set up and is
running properly.
3. Clean all rust protected surfaces (bed,
fence, etc.) with kerosene or diesel oil.
7