Advertisement
(3). Please try to charge after the battery power is completely
used up. Ensure as far as possible when charging a full, do
not outage of the power。 （The first charge time is suggest
to be 12 hours, afterwards will be 8 hours. In order to
avoid damage to the battery, and the emitter, please full the
plug after a full charge.）
VII. Transportation
7.1 Disassembly：
Please according to the following methods, to keep the transport
safety and convenient：
(1). First, the machine should stop the working, check if you
had shut down all the parts.
(2). Disassembly the laser transmitter and the laser receiver
（Forbid to pull the plug when not cut the power） ， and put
them back in the right boxes.
(3). Disassembly the vibration plate from the machine, take out
the aluminium tubes, pull out the pin which connect the
vibration plate and the machine, then you can separate
them（Attention，before disassembly the above parts, you
should assemble
the wheel as below first.）
Tel:(+86)17737606271
21
Henan Master Machinery Co., Ltd
www.mastermachinerys.com
Advertisement
