Setup And Assembly; Shipping Contents; Tools Required For Assembly - Powermatic PM2000B Operating Instructions And Parts Manual

Read and understand the
entire contents of
attempting set-up or operation. Failure to
comply may cause serious injury.

6.0 Setup and assembly

6.1 Shipping contents

See Figure 6-1.
Remove all accessory boxes from shipping pallet.
Remove items from inside cabinet. Do not discard
any packing material until saw is assembled and
running satisfactorily.
Compare contents of your container with parts list
below to make sure all parts are intact. Any
missing parts should
distributor. (Check saw first in case parts were
preinstalled.)
1 Cabinet saw with switch – A
2 Cast iron extension wings – B
1 Miter gauge assembly – C
1 Motor cover with hinge pins – D
1 Push stick – E
1 Arbor wrench – F
1 Caster elevating handle – G
2 Handles – H
1 Handwheel – J
1 Handwheel lock knob – K
1 Blade guard – L
1 Low profile riving knife – M
1 Riving knife – N
1 Anti-kickback pawl assembly – O
1 Table insert (preinstalled) – P
1 Blade (preinstalled)
1 Product registration card
1 Operating Instructions and Parts Manual
1 Hardware package
6.1.2 Hardware package #PM2000B-HP
See Figure 6-2.
6 Hex cap screws, M10x35 (HP1)
6 Lock washers M10 (HP2)
6 Flat washers M10 (HP3)
NOTE: Fence and rail assemblies with fasteners,
and wood extension tables and legs with fasteners,
are shipped in separate boxes.

6.2 Tools required for assembly

Hex key 2.5mm
Open end wrenches: 14mm, 17mm
Straight edge
Rubber mallet (or hammer with block of wood)
Note: A ratchet wrench with sockets will speed
assembly time. Additional tools may be needed for
assembly of fence and rails.
this manual before
be reported to your
Figure 6-1 (items not to scale)
Figure 6-2 hardware package (PM2000B-HP)
10