Garmin GPSMAP 740 Owner's Manual page 91

Configuring Waypoint Identification
1. From the Home screen, select Configure > Communications > NMeA 0183 Setup > Waypoint IDs.
2. Complete an action:
• Select Names to transmit waypoint names via NMEA 0183 while navigating.
• Select Numbers to transmit waypoint numbers while navigating. This option may resolve compatibility
with older NMEA 0183 autopilots.
Viewing NMEA 0183 Diagnostic Information
The NMEA 0183 Diagnostics screen is a troubleshooting tool used by installers to verify that NMEA 0183
data is being sent across the system.
From the Home screen, select Configure > Communications > NMeA 0183 Setup > Diagnostics.
NMEA 2000
GPSMAP 700 series chartplotters are NMEA 2000 certified and can receive data from a NMEA 2000 network
installed on the boat to show specific information, such as depth, speed, water temperature, wind speed and
direction, and engine data.
You can also name your engines and tanks so that you can better identify their location on the boat.
To connect a GPSMAP 700 series chartplotter to an existing NMEA 2000 network and to see a list of
supported NMEA 2000 PGN numbers, see the GPSMAP 700 Series Installation Instructions.
Viewing a List of NMEA 2000 Network Devices
You can view the devices connected to the NMEA 2000 network.
1. From the Home screen, select Configure > Communications > NMeA 2000 Setup > Device List.
2. Select a device for a list of options.
Labeling Engines as Numbers
From the Home screen, select Configure > Communications > NMeA 2000 Setup > Label Devices >
Change engine Labels > Use Numbers.
Labeling Engines as Names
1. From the Home screen, select Configure > Communications > NMeA 2000 Setup > Label Devices >
Change engine Labels > Choose Names.
2. Select the engine you want to name.
3. Select the location of the engine: Port (P), Center (C), Starboard (S), Fore (F), or Aft (A).
4. Select the label you want to use for the engine.
Labeling Tanks as Numbers
1. From the Home screen, select Configure > Communications > NMeA 2000 Setup > Label Devices >
Change Tank Labels.
2. Select the type of tank you want to label.
3. Select Use Numbers.
Labeling Tanks as Names
1. From the Home screen, select Configure > Communications > NMeA 2000 Setup > Label Devices >
Change Tank Labels.
2. Select the type of tank you want to label.
3. Select Choose Names.
4. Select a tank.
5. Select the location of the tank: Port (P), Center (C), Starboard (S), Fore (F), or Aft (A).
6. Select the label you want to use for the tank.
GPSMAP 700 Series Owner's Manual
Appendix
87