Table of Contents
Advertisement
DP-1
ON
Interface unit (10P0047) adjustment
If the E/S picture on the screen does not have the desired coloration, perform the
adjustment as follows with the preset potentiometers on the I/O board in the interface unit.
Interface board
(10P0047)
Setting for DIP switch
S01:
S02:
Talker check (only for NMEA signal)
Talker is checked.
Talker is not checked.
Talker of GP, SD, VD, etc. is checked.
Depth (Echo sounder, Color Video Sounder, etc.)
Input Device
Echo Sounder *
CIF or NMEA line
Depth data is selected with S5.
*: Use this position for white line pulse when the depth data is taken from
an echo sounder. However late model FURUNO echo sounders do not
output white line pulse. Normally set to ON.
S01
The FNZ marker is plotted on the echo sounder picture with this
switch turned on when FNZ marker signal is fed to External Interface.
Factory setting is the "ON" position.
Selects the signal mode (AC or DC) according to the combined echo
sounder connected. Factory setting is the "AC" position.
S4
OFF
ON
S5
OFF
ON
7-6
R27
R36
R55
R56
S02
Advertisement
Table of Contents
