Fabrication of cable 10S1259 (connected to terminal board TB-D2
in raise/lower control box)
4.8 Connection of Transducer Cables
The transducer cables come with connectors attached. Plug the connectors into the proper re-
ceptacles on the receiver unit, referring to the labels on the cables.
Lead the cables into the receiver unit and
clamp them as shown below.
Cable clamp
Armor
30
5
70
Figure 4-22 Fabrication of cable 10S1259
1. Connect transducer cables
to the XRS terminal board
referring to labels inside
the receiver unit.
2. Connect ground wires to
slip-on terminals.
Transducer
P1
P2
cable
P3
P4
TD COMMON
P5
Ground wire
Transducer cable entrance
Seal with putty.
Sleeve
Vinyl tape
Figure 4-23 Receiver unit, rear view
4-13
3.5sq
M4 (YEL) x 3
x 3
1.25sq
M4 (RED) x 2
x 2
Note: Use the connector puller
(supplied) whenever
unplugging connectors.
Connector
Puller
Comments to this Manuals
Latest comments: