Furuno 1824C Installation Manual page 69

4.2.2 Connecting an external monitor
You can display the MODEL1824C/1834C/1934C/1944C/1954C screen on an external
monitor which accepts industrial standard VGA input by using the optional RGB output
cable kit OP03-176. Supply monitor and interconnection cable (with HD-15P connectors of
male, three rows of 15 pins) locally.
Necessary parts for external monitor
Name: RGB output cable kit
Type: OP03-176
Code No.: 008-526-360
Name
Cable assy. 15SDS/XHP10-005
Grommet MG-4
1. Unscrew 15 binding screws (M3x10, w/nylon washer) and seven connector nuts to
remove the display unit cover.
2. Cut a "cross" in the grommet (to pass the cable).
3. Pass the RGB output cable through the grommet hole at the rear of the display unit
cover and the saddle on the POWER Board, and then connect the XH connector (10P)
of the RGB output cable to J110 on the SPU Board. Put the ground wire of the cable
outside of the cover.
4. Reassemble the display unit referring to the illustration on page 4-3.
5. Fix the ground wire of the cable with one of two screws both sides of the connector hole.
6. Finally, cover the hole with soft putty to seal
Binding screws
(M3x10, w/nilon washer)
15 pcs.
Type
000-144-511
000-871-378
Connector nut
(large) 1 pc.
Ground wire
(to the out side
of the cover)
J109
How to connect 15SDS/XHP10-005
Code No. Qty
1
1
Connector nut
(for 24P) 1 pc.
Connector nut
(small) 5 pcs.
RGB output cable
(15SDS/XHP10-005)
Saddle
4-7
Rubber grommet
Cut a "cross"
J110