Furuno 1824C Installation Manual page 58

WAAS setup (requires GPS receiver GP-320B/330B)
Press the WAAS SETUP soft key to show the WAAS SETUP display.
Item
WAAS Mode Select ON to use the WAAS mode.
WAAS WAAS satellite can be searched
Search automatically or manually. For manual
search, enter appropriate WAAS satellite
number.
WAAS Alarm When the WAAS signal is lost, the
audible alarm sounds with the visual
message "NO WAAS SIGNAL."
On: Alarm continues to sound until the
WAAS positioning mode is available
again or the alarm is recognized by key
operation.
Off: Alarm sounds three times.
Corrections Selects the type of message for WAAS
Data correction. Use "00" (operational status)
in North America; "02" in other locations.
39. After you have finished setting up the GPS receiver, it's now time to set up external
equipment. Press the NEXT soft key to show the DATA1 (GPS/NMEA) port setup menu.
It is only necessary to set up ports which you are going to use; skip unnecessary steps.
If you do not have external equipment connected to the NavNet, press the NEXT
key several times to show the "FINISH AND EXIT INSTALLATION WIZARD" screen
and then push the ENTER knob to finish.
OUTPUT FORMAT
LAT/LON FORMAT
XTE FORMAT
OUTPUT DESTINATION NO
Installation wizard, DATA1 (GPS/NMEA) port setup menu
40. Choose item and press the EDIT soft key. Choose appropriate setting and then press
the ENTER soft key. Refer to the table and sentence description on the next page for
details.
41. Press the NEXT key, and the DATA2 (NMEA) port setup menu appears. Set up this port
similar to how you set up the DATA1 port.
OUTPUT FORMAT
BAUD RATE
LAT/LON FORMAT
XTE FORMAT
OUTPUT DESTINATION NO
Installation wizard, DATA2 (NMEA) port setup menu
Contents of WAAS SETUP menu
Description
NMEA0183
Ver 2.0
DD'MM.MMM'
X. XX
NMEA0183
Ver 2.0
4800bps
DD'MM.MMM'
X. XX
3-12
Settings Default Setting
On, Off Off
Auto, Manual Auto
On, Off Off
00 to 27, 99 02