Furuno 1824C Installation Manual page 17

9. Attach connectors of the antenna cable to the locations shown in the figure below, and
then fasten a pan head screw M4x10 to fix shield cable and core case (removed at step
6.)
J810
J809
(13 pin)
(4 pin)
Antenna unit, connector location and fixing the shield cable w/core case
10. Put the EMI core on the antenna cable into the core case attached at step 9, with the flat
side of the core facing downward.
11. Refasten the shield plate and core case cover with 15 screws. Be sure that the cable
from the rotation detector passes through the notch between the two cable ties.
J801
(9 pin)
EMI core
EMI core, putting into core case
Notch
How to pass the rotation detector cable
Pan head screws
M4x10 9 pcs.
Core case
1-9