Furuno 1824C Installation Manual page 33

8. Connect the signal cable to the RTB Board (03P9249 or 03P9250), referring to the
interconnection diagram and the figure below.
9. Attach three EMI cores to the signal cable as shown below.
Lead in
cable here.
EMI core
RFC-13
10. Fix the signal cable with the cable clamp.
11. Release the stay and close the cover. Loosely fasten the scanner bolts; you will have to
make some adjustments inside after completion of wiring.
Note: When closing the cover, set the gaskets to grooves in the bottom chassis, then
tighten bolts.
Route cable along here.
Antenna unit chassis, cover opened
BOTTOM
CHASSIS
GROOVE
GASKET
SCANNER BOLT
.
Torque : 9.8 ±0.1 N m
1-25
RTB Board
J821 VH9P
J822 VH2P
J824 NH13P
J823 VH4P
Clamp