Selecting Image Source - Furuno NAVNET 1734C Operator's Manual

1.5.4 Selecting image source

When more than one network radar or network sounder is connected to the equipment, you
may select an image source for each as shown below. This is not necessary when only one
network radar or network sounder is connected.
1. Press the DISP key.
2. Press any soft key to show the following display.
3. Use the Cursor pad to select RADAR SOURCE, SOUNDER SOURCE or AUX
SOURCE as appropriate, then press the EDIT key.
4. Use the Cursor pad to choose source.
5. Push the ENTER knob to set.
6. Press the DISP key to finish.
7. Turn the power off and on again.
RADAR SOURCE
1 (HOST NAME: NAVNET1)
SOUNDER SOURCE*
SOUNDER _
IP ADDRESS
172.031.003.003
DEVICE NUMBER
2 (HOST NAME: NAVNET2)
IF THERE IS MORE THAN
ONE NETWORK RADAR OR
ECHO SOUNDER, YOU MAY
SELECT THE IMAGE
SOURCES FOR DISPLAY.
Select source menu
RADAR SOURCE
1 (NAVNET1)
¤
2 (NAVNET2)
¡
3 (NAVNET3)
¡
4 (NAVNET4)
¡
Radar source
Radar source and sounder source windows
1. OPERATIONAL OVERVIEW
SELECT
SOURCE
EDIT
RETURN
*: Do not change this setting.
SOUNDER SOURCE
ETR0 (SOUNDER)
¤
ETR1 (SOUNDER1)
¡
ETR2 (SOUNDER2)
¡
ETR3 (SOUNDER3)
¡
ETR4 (SOUNDER4)
¡
ETR5 (SOUNDER5)
¡
ETR6 (SOUNDER6)
¡
ETR7 (SOUNDER7)
¡
ETR8 (SOUNDER8)
¡
ETR9 (SOUNDER9)
¡
Sounder source
1-11