Troubleshooting - FujiFilm 4700 Owner's Manual

Warning Displays
Explanation
Warning Displayed
LCD Monitor LCD Panel
The image you tried to erase has
D P O F S P E C I F I E D .
—
a DPOF print setting.
E R A S E O K ?
The DPOF file contains an error.
— Alternatively, the DPOF file was
set up on a different device.
Prints were specified for more
— than 999 frames in the DPOF
frame settings.
• The lens cover is not open.
• Camera malfunction or fault.
114
Remedy
When you erase the image, the DPOF
settings for that image are deleted at the same
time.
Press the MENU/EXE button to create a new
DPOF file and specify all the DPOF settings
again.
The maximum number of frames for which
prints can be specified on the same
SmartMedia is 999.
Switch the camera on again, ensuring that you
are not touching the lens cover at the
time.Switch the camera off and then on again
a few times.

Troubleshooting

Problem Cause
No power • The battery is exhausted.
• The AC power adapter plug has come out of
the power outlet.
Power cuts out during • The battery is exhausted.
operation.
Battery runs out quickly. • You are using the camera in extremely cold
conditions.
• The terminals are soiled.
• The battery is flat.
No photograph is taken • No SmartMedia is loaded.
when the shutter button is • The SmartMedia is fully recorded.
pressed.
• The SmartMedia is write-protected.
• The SmartMedia is not formatted.
• The SmartMedia contact area is soiled.
• The SmartMedia is damaged.
• The Auto Power Off function has switched
the camera off.
• The battery is exhausted.
If you think the camera is faulty, check the following once more
Remedy
• Load a new fully charged battery.
• Plug the adapter back in.
• Load a new fully charged battery.
• Put the battery in your pocket or another
warm place to heat it and then load it into
the camera just before you take a picture.
• Wipe the battery terminals with a clean, dry
cloth.
• Load a new fully charged battery.
• Load a SmartMedia.
• Load a new SmartMedia or erase a frame.
• Remove the write-protection.
• Format the SmartMedia.
• Wipe the SmartMedia contact area with a
clean dry cloth.
• Load a new SmartMedia.
• Switch the camera on.
• Load a new fully charged battery.
115