FujiFilm 4700 Owner's Manual page 59

Troubleshooting
Problem
I can't use the flash to take • The Mode switch and Photography mode
pictures. dial has been moved to another setting.
• The flash is set to Suppressed Flash
mode(The flash is closed).
• You pressed the shutter button while the
flash was charging.
The flash will not charge. • No compatible SmartMedia is loaded.
• The camera is set to Suppressed Flash
mode.
• The camera is set to Macro Photography.
• The battery is exhausted.
The playback image is too • The subject is too far away.
dark even though I used • Your finger covering the flash.
the flash.
The image is blurred. • The lens is dirty
• The lens is zoomed to telephoto in Macro
mode.
I cannot format the • The SmartMedia is write-protected.
SmartMedia.
I cannot erase all the • The frame is protected.
frames.
116
Cause Remedy
• Set the Mode switch and Photography
mode dial to the correct setting.
• Set the flash to Auto, Red-Eye Reduction or
Forced Flash mode(Pop the flash unit up).
• Wait until charging is completed before
pressing the shutter button.
• Load a new SmartMedia, erase a frame, or
remove the write-protection.
• Set the flash to Auto, Red-Eye Reduction or
Forced Flash mode.
• Cancel Macro Photography.
• Load a new battery.
• Move closer to the subject.
• Hold the camera correctly.
• Clean the lens.
• Cancel Macro mode.
• Remove the write-protection.
(Peel off the write-protect sticker.)
• Remove the frame protection.
Problem Cause
Nothing happens when I • Camera malfunction.
use the camera switches
and dial. • The Mode switch and Photography mode
dial has been moved to another setting.
• The battery exhausted.
No image appears when I • The Mode switch and Photography mode
press the, "DISP" button. dial has been moved to another setting.
There is no sound. • sounThe camera volume is set too low.
• The microphone was covered during
recording.
• The A/V cable is connected.
There is no picture or • The A/V cable is connected during movie
sound on the TV. playback.
• The camera and TV are connected
incorrectly.
• The TV input is set to "TV".
• The volume on the TV is set too low.
Remedy
• Use the "POWER" switch to switch the
camera on again.
• Remove the battery, re-insert them and try
again.
• Load a new battery.
• Move the Mode dial to the correct setting.
• Adjust the volume.
• Take care not to cover the microphone
when recording.
• Disconnect the A/V cable.
• Connect the A/V cable correctly.
• Connect the TV and camera correctly.
• Set the TV input to "Video".
• Adjust the volume.
117