JRC JSS-2150 Instruction Manual page 209

2 2 . .
2 .
Pass the roll bar through the roll paper,
and install the roll paper onto the roll paper
stand in the right direction.
When passing the roll bar through the roll
paper, push the roll bar all the way in.
3 3 . .
3 .
Pass the roll paper over the guide bar as
shown in the figure at right.
Adjust the side guides to the paper width.
4 4 . .
4 .
Insert the leading edge of the paper into
the rear of the platen. Then turn the paper
feed knob to feed the paper out and adjust
the direction.
After adjusting the paper direction, return the
friction lever to the back to fix the paper.
5 5 . .
5 .
Restore the roll paper cover and the roll
support cover as shown at right and close
the printer cover.
6 6 . .
6 .
Turn on the printer power.
- When turning on the printer holding
Note
down the LF/FF key, the print test of
alphanumeric characters is started
automatically.
- To finish the print test, turn off and on
the power.
Options Operation
Side guide
Platen
Guide bar
10-13