Telex Communication Screen - JRC JSS-2150 Instruction Manual

2.4.2

Telex communication screen

1
2
3
1. Indicates the operating condition of the
telex communication from the left of each
segment as follows.
1） In the autotelex mode, when the free
channel signal of the coast station is
detected, indicates the "Free Sig".
2） Indicates the communication mode
(ARQ/CFEC/SFEC).
※ Indicates "ST-BY" in the standby
condition.
3） Indicates "Calling"
station, and "Called" at the slave
station.
4） Indicates "Send" at the information
sending station, and "Receive" at the
information receiving station.
5） Indicates "Phasing" while calling and
connecting
channel and
reconnecting the channel after the
channel is disconnected due to the
channel condition in ARQ mode.
6） Indicates "Repeat" in ARQ mode if
requested to send the each block or
the control signal again.
7） Indicates "Traf"
receiving information and "RQ" while
sending or receiving RQ signal.
at the master
the communication
"Rephasing" while
while sending or
2. Indicates the telex message or the name
of the executed function key.
3. Indicates the usable function keys guide.
Each meaning is as follows.
 F2 WRU ： Requests the answer-
 F3 Hereis ： Sends the answerback
 F4 TMS ： Sends the date and the
 F5 Over ： Exchange the sending
 F6 POLL ： Acquires the sending
※ It is available only when the
corresponding station is using the
modem made of our company.
 F8 F.Send ： Sends a message file.
 F10 Stop ： Finishes
Names and Functions
back code to the
corresponding station.
code of own station.
time information.
and the receiving
condition.
right if the correspond-
ing station (sending)
tries to finish the
communication in ARQ
mode.
the telex
communication.
2-11