Bam Alert - JRC JSS-2150 Instruction Manual

Maintenance & Inspection

6.3 BAM alert

This section describes the indications and functions of BAM (Bridge Alert Management).
The ON/OFF of the BAM (Bridge Alert Management) alert function has be set
in the equipment installation. If you need to change the setting, consult with
us or our agents.
6.3.1 Alert state indications
The alert marks are indicated at the top of the screen while an alert is occurring.
multiple alerts, the state of the highest priority alert is indicated.
① Priority
Indicates the priority of the alert.
There are two types of priorities shown below,
Warning is an alert with higher priority than
Caution.
W Warning
C Caution
② State
Indicates the state of the alert.
There are five types of states shown below.
V Active unacknowledged
The operator has not confirmed the Warning alert.
S Active Silenced
The alert sound of the Warning alert has been temporarily silenced by the CAM device
(MFD, etc.).
U Rectified unacknowledged *Flashing indication
Operator's unconfirmed the Warning alert has been restored.
O Active responsibility transferred
The Warning alert management has been transferred to the CAM device (MFD, etc.).
A Active acknowledged / Active
The operator has been confirmed the Warning alert.
Or, The Caution alert has been occurring.
6-6
CAUTION
Alert marks
*Flashing indication
*Flashing indication
② State
① Priority
I D 4 31 0 01 2 34
P os 89 ﾟ 5 9. 0 12 3 'N
1 79 ﾟ 5 9. 6 78 9 'E @ 23 : 59
TEL ITU- 401
4357.00
RX
4065.00
TX
S IG
W KR sc a n b an d s:
2 4 6 8 1 2 1 6 MH z
If there are
: +
W V M 9
ENU
G
PS
D
UP
kHz
kHz
12 -S N2
N o n D S T : +
M 1
ENU
D R O B O S : +
M 2
ENU
E d t D S T : +
M 3
ENU