Table of Contents
Advertisement
Remote Control, cont'd
4.
Follow the on-screen instructions. By default, the
installation of the Universal Switchers Control Program
creates a C:\Program Files\Extron\UniversalSwitcher,
and it places four icons into a group folder named "Extron
Electronics\Universal Switcher." The four installed icons
are:
•
Check for Universal Switcher Updates
•
Uninstall Universal Switcher
•
Universal Switcher Control Program
•
Universal Switcher Help
Using the software
Run the program as follows:
1.
Click Start > Programs > Extron Electronics > Universal
Switcher (New) > Universal Switcher Control Pgm.
2.
Click the comm port that is connected to the switcher's
RS-232 port.
3.
The Extron Universal Switcher Control Program window
(figure 3-4) displays the selected video and audio input.
Figure 3-4 — Universal Switcher Control program
window
MTP SW6 • Remote Control
3-16
To set up for audio follow switching (the output has the same
•
audio and video input selected), select the Audio and Video
check boxes. To set up for audio breakaway switching (the
output has different audio and video inputs selected), deselect
the Audio or Video check box.
To select an input, click the input button.
•
To set the input audio level (gain and attenuation), click the
•
Gain/Att tab.
To adjust the level and peaking, click the Level/Peak tab.
•
To select or deselect auto switch mode, click the Auto Switch
•
tab.
To set the output volume, click the Volume tab.
•
To set the RS-232 or audio definition for wire pair 3 and 6, click
•
the RJ-45 tab.
To set the skew adjustments, click the Skew tab.
•
Using the help system
For information about program features, you can access the help
program in any of the following ways:
•
Click Start > Programs > Extron Electronics > Universal
Switcher Help.
•
From within the switcher control program, select Help >
Contents on the task bar.
•
From within the switcher control program, press the F1
key.
MTP SW6 • Remote Control
3-17
Advertisement
Table of Contents
