Table of Contents
Advertisement
ELECTRICAL INSTALLATION – 810TR, 8100TR & 8611TR MODELS
NOTE: 760TR, 860TR, and 8600TR models do not
require electrical connections between the tractor
and the snowplow.
1. Connect the coil harness to the solenoids
according to the illustration below. Feed the
opposite end of the harness through the top
access hole in the A-frame, and route the harness
into the tractor making sure to secure it so it will
not get pinched during use.
1) WHT – S1 (left slide box)
2) BLK – Ground
1) RED – S2 (angle isolation)
2) BLK – Ground
1) GRN – S3 (right wing)
2) BLK – Ground
Lit. No. B64092, Rev. 09
TR COIL HARNESS (B62264)
(end view)
(end view)
(end view)
2. Connect the tractor end of the coil harness to the
tractor's auxiliary electrical system according to
the vehicle's owner's manual or service manual.
3. Complete the assembly by reattaching the
A-frame cover. Align the holes in the cover
with those on the A-frame and secure it with
3/8" x 1-1/2" cap screws and 3/8" washers.
BLK
22
WHT
Tractor
GRN
April 15, 2021
To
Wiring
Advertisement
Table of Contents
