Blizzard 760TR Installation Instructions & Owner's Manual page 17

MOLDBOARD & A-FRAME ASSEMBLY – 760TR, 860TR & 8600TR MODELS
9/16"
9/16"
40571
• Angle Cylinders
4. Hook each extension spring to the receiving holes
on the pivot beam and attach the opposite end of
the spring to its respective spade bolts. Install the
spade bolts through the extension spring mounting
angle on the top rear of the blade. Secure each
spade bolt by placing one 5/8" fl at washer on the
bolt and thread one 5/8" locknut. Tighten each
locknut until a piece of paper can pass between
the 3rd and 4th coils on the spring.
Locknut
Washer
Lit. No. B64092, Rev. 09
3/4"
B60403
• Manifold Ports
Spade
Bolt
Spring
9/16"
17/32"
5. Install the blade guides at each end of the
moldboard by inserting the cap screws through
the holes at the top of the wing reinforcement rib.
Tighten all screws with locknuts.
17
9/16"
B60539
• Angle Cylinders
April 15, 2021
25/32"