Testing Your Snowplow - Blizzard 760TR Installation Instructions & Owner's Manual

TESTING YOUR SNOWPLOW – ALL MODELS
1. To test all of the functions, your snowplow needs
to be properly attached to the tractor. Refer to the
Mounting and Dismounting label on the back of
the snowplow.
2. Complete the hydraulic connections with the
tractor turned OFF.
NOTE: Due to the various makes and models of
tractors available, hydraulic couplings for the
auxiliary hydraulic connections are not provided.
Consult your tractor's owner's manual for the
appropriate couplings needed.
For 810TR and 8611TR Models: Connect the
couplings to the loose hoses coming from the
pressure ports ("P2" and "P3") and the tank port
("T") on the manifold.
For 760TR, 860TR, and 8600TR Models:
Connect the couplings to the loose hoses coming
from each ram.
Complete the hydraulic installation by making the
appropriate connections at the tractor.
3. Start the tractor and begin to initiate the blade
functions.
Lit. No. B64092, Rev. 09
NOTE: Depending on the tractor model, it may
be necessary to turn ON the tractor's auxiliary
hydraulic switch prior to operating the snowplow.
Activate each function of the snowplow.
For 810TR and 8611TR Models: Extend and
retract the driver-side wing a few times, then
extend and retract the passenger-side wing. Angle
the blade left and right a few times.
For 760TR, 860TR, and 8600TR Models: Angle
the blade left and right a few times.
Upon initiating the snowplow functions, you may
notice a snowplow function is slow or delayed.
The hydraulic fl uid is fi lling the cylinders and
replacing air in the system. Monitor the hydraulic
fl uid level in your tractor and fi ll as necessary.
NOTE: This snowplow uses the tractor controls
for an emergency stop. See tractor manual for
details.
24 April 15, 2021