Table of Contents
Advertisement
ELECTRICAL INSTALLATION
If the vehicle is equipped with fused battery studs, the
plow battery cables should not be attached to the
fused side (see below).
MOUNT ADAPTER MEASUREMENT
With the vehicle on level ground, measure from the
ground to the center of the hole on the U-bracket side
plate of the mount.
The height of the mount should be 14-1/4" or less from
the center of the U-bracket hole to level ground. If the
measured height is 14-1/4" or less, no mount adapter
height adjustment is required.
If the measured height is 14-1/4" to 16", install the
short height adjustment adapter plates to the mount
adapter as described. (The mount adapter comes
packaged with the blade crate assembly.)
Center
of Hole
Adapter
Plate
Mount
Adapter
Lit. No. 41606, Rev. 01
MOUNT ADAPTER INSTALLATION
Mount
14-1/4" to 16"
MOUNT ADAPTER INSTALLATION
If adapter plates are required, install as follows:
1. Position an adapter plate against the driver's side
portion of the mount adapter as shown. Insert a
3/4" x 2-3/4" cap screw through the lower front
adapter plate hole and through the appropriate
hole on the mount adapter. Secure with a locknut.
Mount Adapter
3/4" Locknut
3/4" x 2-3/4" Cap Screw
2. Insert a cap screw through the rear adapter plate
hole, through the slot on the mount adapter and
through a washer. Secure with a locknut.
3. Repeat for the passenger's side. Tighten all
fasteners according to the torque chart.
When positioning the mount adapter between the
undercarriage brackets, insert a spacer between
the adapter plate and the inner side plate of the
undercarriage as shown.
Spacer
Hairpin
Cotter
Washer
NOTE: After fi ve to ten hours of snowplow usage,
retorque all undercarriage assembly fasteners.
7
3/4" Washer
Adapter
Plate
Clevis Pin
Adapter
Plate
January 1, 2012
Advertisement
Table of Contents
