Assembly; Tractor Preparation; Snowblower Assembly; Installation Of Chute - Blizzard B74C Operator And Parts Manual

T P
RACTOR REPARATION
See Dealer for Tractor Preparation information.
S
NOWBLOWER
The snowblower is assembled at the factory except for the parts in the hardware bag provided with the
snowblower, the chute and the options if appropriate. Use the present manual and lay out all parts for
assembly. Separate bolts and nuts into various sizes. After assembly, torque all the bolts according to the
Torque Specification Table at the end of manual.
Installation of the Chute
(Figure 1)
1. Figure 1: Place the rotation bushing (item 1)
on the chute base of the snowblower.
2. Figure 1: Install the chute (item 2) over the
rotation bushing and install the three 3/16"
spacers (item 3) and the 3/8" spacers (item 4).
Figure 1
OM 0410SB-A

ASSEMBLY

A
SSEMBLY
3. Figure 1: Insert the two three holes retaining
plates (item 5) by placing the large section
toward the support of the hydraulic motor.
Secure with two 1/2"NC x 3/4" carriage bolts
(item 7), upside down (front of the chute) and the
four other bolts head up (rear of the chute).
Secure with six 1/2" lockwashers (item 8) and
four 1/2"NC hex nuts (item 9).
4. Tighten all bolts according to the Torque
Specification Table at the end of the manual.
13