Table of Contents
Advertisement
MOLDBOARD & A-FRAME ASSEMBLY – 810TR, 8100TR & 8611TR MODELS
9. Assemble the manifold. Each of the hose ports on
the manifold is covered with stretch wrap. Remove
the wrap and install adapter (56695) in ports #1, 2,
7, 8, 9, and 10. Tighten fi ttings per torque chart.
7
8
NOTE: DO NOT let any foreign objects enter
into the open ports. The valves can become
contaminated and greatly hinder the snowplow's
performance. Torque to proper specifi cations.
NOTE: All ports are identifi ed by a stamped
number on the manifold. The numbers also
identify the hydraulic functions, which can be
referenced on the label under the manifold cover.
10. Remove the A-frame cover to gain access to the
inside of the manifold compartment.
11. Attach the manifold to the A-frame using cap
screws (B61514), washers (29233) and locknuts
(B61034).
8611TR
Model
Lit. No. B64092, Rev. 09
1
10
2
9
Manifold
Mount Holes
NOTE: When handling the manifold, hold the
manifold at the sides of the block. Never handle
the manifold by coils. Doing so can cause a
solenoid cartridge to bend, causing the cartridge
to stick when activated.
12. Route the hydraulic hose groupings from the pivot
beam to the access holes located on the sides of
the A-frame. Connect the hoses to their respective
adapters on the manifold.
13. Remove the dust cap from both of the
hydraulic angle cylinder ports and attach one
9/16" 90° adjustable elbow ORB adapter (40571)
to each port. Each adapter should be angled
toward the top of the moldboard. Connect one
3/8" x 26" (36" for 8611) hydraulic hose (B60223
or 49501) to each angle cylinder adapter. Be
careful not to overtighten the hose connections.
Tighten fi ttings and hoses per torque chart.
14. Connect the hoses to their respective adapters on
the manifold. Tighten hoses per torque chart.
15. Install adapter (B60340) to port "T" on the
manifold. Connect a 1/2" x 115" hydraulic hose
(B60531) to the "T" adapter, and connect
3/8" x 115" hydraulic hoses (B60473) to the
"P2" and "P3" adapters. Tighten fi ttings and hoses
per torque chart.
T
15
P3
P2
April 15, 2021
Advertisement
Table of Contents
