Table of Contents
Advertisement
S
NOWBLOWER
The snowblower is assembled at the factory,
however, snowblower kit must be assembled.
Use the present manual and lay out all parts for
assembly. Separate bolts and nuts into various
sizes. After assembly, torque all the bolts
according to the Torque Specification Table
enclosed at the end of the manual.
Driveline Installation
1. Remove paint from snowblower gearbox drive
shaft and grease driveline sliding surfaces
and yoke.
2. Remove the bolt of the yoke and slide
driveline yoke over drive shaft using sliding
action of the driveline. Make sure the driveline
is well secured to the drive shaft by replacing
the bolt and tightening it according to the
torque specification table.
Figure 1
OM 0279-A
ASSEMBLY
A
SSEMBLY
Chute & Manual Rotation
1. Place the anti-friction ring (fig.2, item 4) over
the chute base, placing the raised part upside
and toward the center of the frame.
Figure 2
2. Insert the 1 11/16''lg. plastic bushing (fig.4,
item 11) in the worm rotation bracket (fig.4,
item 6). Grease the two ends of the rotation
worm (fig.4, item 5) and insert the rotation
worm in the bushing (fig.4, item 11).
3. Insert the 1 5/16'' plastic bushing (fig.4, item
10) in the tube welded behind blower (fig.3,
item 1)
4. Install the assembly by placing the worm
rotation bracket (fig.4, item 6) under the right
upper plate of the snowblower (fig.3, item 2).
Figure 3
10
1
2
Hide quick links:
Advertisement
Table of Contents
