Touch Up Any Damaged Paintwork; Inspection And Maintenance; Safety Instructions For Inspection And Maintenance - Siemens SIMOTICS DP Operating Instructions Manual

Maintenance

9.2 Inspection and maintenance

9.1.2

Touch up any damaged paintwork

If the paint is damaged, it must be repaired in order to protect the unit against corrosion.
Note
Paint system
Contact the Service Center before you repair any damage to paint. They will provide you with
more information about the correct paint system and methods of repairing paint damage.
9.2 Inspection and maintenance
9.2.1

Safety instructions for inspection and maintenance

Danger as a result of stationary parts under voltage (live parts)
Live parts represent a hazard. Touch protection against active (live) parts is no longer
guaranteed if covers are removed. The minimum air and creepage distances may be fallen below
(violated) when coming close to active parts. Touching or coming close can result in death,
serious injury or material damage.
• Take the machine out of operation.
• Switch off the machine and ensure that it is in a no-voltage condition. Carefully comply with
the "5 safety rules" (Page 11).
• Only open the terminal box when the motor is stationary and in a no voltage condition.
Risk of injury due to rotating parts
Rotating parts are dangerous. Touch protection against rotating parts is no longer guaranteed
if covers are removed. Touching rotating parts can result in death, serious injury or material
damage.
• Before carrying out any repair work on the machine, take it out of operation, and carefully
lock it out so that it cannot be switched on again.
• Only remove the covers when the rotating parts have come to a complete standstill.
Risk of burn injuries due to hot surfaces
In operation, the temperature of individual machine parts can increase - and only decrease
slowly after switching off. You can burn yourself if you touch hot surfaces.
• Allow the machine to cool before starting any maintenance and service work on the machine.
• Check the temperature of parts before touching them. If required, wear suitable protective
equipment.
96
1FZ shaft height 280
Operating Instructions, 02/2022, A5E51698698A