Preparing For Use; Safety-Related Aspects To Consider When Configuring The Plant; Observing The Operating Mode; Machines Without Final Paint Coating - Siemens SIMOTICS DP Operating Instructions Manual

Preparing for use

Good planning and preparation of machine applications are essential in terms of keeping
installation simple and avoiding errors, ensuring safe operation, and allowing access to the
machine for servicing and corrective maintenance.
This chapter outlines what you need to consider when engineering/configuring your plant in
relation to this machine and the preparations you need to make before the machine is delivered.
4.1

Safety-related aspects to consider when configuring the plant

A number of residual risks are associated with the machine. These are described in the chapter
titled "Safety information" (Page 11) and in related sections.
Take appropriate safety precautions (covers, barriers, markings, etc.) to ensure the machine is
operated safely within your plant.
4.2

Observing the operating mode

Observe the machine's operating mode. Use a suitable control system to prevent overspeeds,
thus protecting the machine from damage.
4.3

Machines without final paint coating

For machines, which are only delivered with primer, you must paint them to comply with the
applicable guidelines for the specific application. The primer alone does not provide adequate
corrosion protection.
Please contact the Service Center for recommendations relating to the paint finish.
4.4

Delivery

Checking the delivery for completeness
The drive systems are put together on an individual basis. When you take receipt of the delivery,
please check immediately whether the items delivered are in accordance with the
accompanying documents. Siemens will not accept any claims relating to items missing from
the delivery and which are submitted at a later date.
• Report any apparent transport damage to the delivery agent immediately.
• Report any apparent defects/missing components to the appropriate SIEMENS office
immediately.
1FZ shaft height 280
Operating Instructions, 02/2022, A5E51698698A
4
29