Vertical Types Of Construction With Flange; Removing The Rotor Shipping Brace; Recommended Alignment Accuracy - Siemens SIMOTICS DP Operating Instructions Manual

Assembly
5.6 Installing the machine
5.6.2.4

Vertical types of construction with flange

The standard flange is provided with a centering. The choice of fit for the mating flange on the
driven machine is the system manufacturer's or the plant operator's responsibility.
If the machine is not fitted with a standard flange, align the machine to suit the driven machine.
Procedure
The machine axis must be vertical when it is lifted and the flange must be parallel to the mating
flange, so as to avoid seizing and stressing. Otherwise damage to the centering will result.
1. Grease the centering flange with assembly paste to make the process easier.
2. Screw in two studs into tapped holes on opposite sides of the driven machine flange. The
studs act as positioning aids.
3. Lower the machine slowly toward the driven machine and into the centering, so that the
flanges do not quite touch. Lowering too quickly risks damaging the centering.
4. If necessary, rotate the machine into the right position so that the clearance holes in the
flange are central to the tapped holes.
5. Lower the machine completely onto the mating flange so that it is fully in contact; then
remove the studs.
6. Fix the machine using the flange fixing bolts.
5.6.3

Removing the rotor shipping brace

If a rotor shipping brace is attached to the machine, remove it at the last possible moment,
for example, when you are ready to push on the output or drive element.
Storing the rotor locking device
Store the rotor locking device in a safe place. It must be remounted if the machine is removed
and shipped on further.
5.6.4

Recommended alignment accuracy

The alignment accuracy required depends essentially on the configuration of the overall
machine train. Observe the required alignment accuracy of the coupling manufacturer in all
cases when aligning the machine.
Table 5-2
58
Recommended alignment accuracy
Speed
rpm
0 ... 900
900 ... 1800
1800 ... 3600
Parallel offset
mm mm per 100 mm coupling diameter
0.09
0.06
0.03
Operating Instructions, 02/2022, A5E51698698A
Angular misalignment
0.09
0.05
0.025
1FZ shaft height 280