Glossary - Eaton EX Pulsar Series Installation And User Manual

6. Appendices
6.2 Programming the Programmable Outlets
6.3

Glossary

1. To open the Setting window, left-click on Start Menu / Programs / EATON / Personal Solution Pac / Settings,
or right-click on the PSP power plug located in the SYS Tray.
Bypass AC input
2. Click on the "+" symbol next to "UPS Settings" to expand the "UPS Settings" section.
Backup time
Battery test
Equipments
Excessive discharge
FlexPDU
Frequency converter
HotSwap MBP
Low-battery warning
LCD
Normal AC input
Percent load
Personalization
3. Click on "Startup Timer" and change the "The group of outlets restarts after" to "0" to have powershare outlet
Programmable
provide power at the same time the as main outlets.
Outlets
Start on battery
power
UPS
UPS ON/OFF
Controlled by
software
86-86710-00EN A02 - Page 28
86-86710-00 A02 UM.indd 31 86-86710-00 A02 UM.indd 28
Bypass line from the AC power source, controlled by the UPS, used to directly supply the
load if an overload or a malfunction occurs on the UPS.
Time during which the load can be supplied by the UPS operating on battery power.
Internal UPS test to check battery status.
Devices connected to the UPS output.
Battery discharge beyond the permissible limit, resulting in irreversible damage to the
battery.
Module with UPS outlets for installation in a bay. There are different modules with dif-
ferent types of outlets.
Operating mode used to convert the AC power frequency between the UPS input and
output (50 Hz -> 60 Hz or 60 Hz -> 50 Hz).
UPS manual-bypass module for maintenance. There are different modules with differ-
ent types of outlets.
This is a battery-voltage level indicating that battery power is low and that the user
must take action in light of the imminent break in the supply of power to the load.
Liquid Crystal Display.
The AC power line supplying the UPS under normal conditions.
Ratio of the power effectively drawn by the load to the maximum output of the UPS.
It is possible to modify certain UPS parameters set in the factory. Certain UPS functions
can also be modified by the Personal Solution-Pac software to better suit user needs.
These outlets can be automatically shut down during operation on battery power
(shutdown time delays can be programmed with the Personal Solution Pac software).
The UPS has two sets of two programmable outlets.
The devices connected to the UPS can be started even if AC power is not available.
The UPS operates on battery power alone.
Uninterruptible Power Supply.
This function enables or disables initiation of UPS ON/OFF control sequences by
computer pwower management software.
26
6. Appendices
86-86710-00EN A02 - Page 31
14/01/2009 10:56:32 14/01/2009 10:56:32