Table of Contents
Advertisement
4. Remove any shipping tape from your label stock roll to ensure that it can unroll freely, making
certain that no adhesive portion is exposed.
IMPORTANT!
5. Place the supply on the roll arm and push it inward until it touches the roll stop.
Roll Stop
Roll Guide
Roll Arm
6. Flip the roll guide up and slide it inward until it touches the label supply.
The roll guide will automatically pull back slightly to the correct position. There should be
approximately a 1mm gap between the roll guide and the roll.
7. Pull the movable throat guide outward to make room for the label supply.
BradyJet J4000 User Manual
Any exposed adhesive surface can attach itself to the inner workings of the print
mechanism and cause a media jam.
Ethernet Network
Installing Label Supply
12
Advertisement
Table of Contents
