Jumper Location
Clearing CMOS and Password Settings
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in
"Safety, Environmental, and Ergonomic Instructions" on page 48.
1 Follow the procedures in "Before You Begin" on page 37.
2 Reset the current CMOS settings:
Locate the 2-pin CMOS jumper (J16) on the system board (see "Jumper Location" on page 60).
a
Remove the jumper plug from the "Normal" position.
b
Place the jumper plug in the "Reset CMOS" position and wait approximately five seconds.
c
Replace the jumper plug in the "Normal" position.
d
3 Replace the computer cover (see "Replacing the Computer Cover" on page 47).
NOTICE:
To connect a network cable, first plug the cable into the network port or device, and then plug it into the
computer.
4 Connect your computer and devices to electrical outlets, and then turn them on.
60
Appendix