Table of Contents
Advertisement
NOTICE:
To avoid damage to the memory module, press the module straight down into the connector while you
apply equal force to each end of the module.
4 Push the module forward into the connector (1), then press down until the module snaps into position
(2).
If you insert the module correctly, the securing clips snap into the notches at each end of the module.
5 Replace the computer cover (see "Replacing the Computer Cover" on page 47).
NOTICE:
To connect a network cable, first plug the cable into the network port or device, and then plug it into the
computer.
6 Connect your computer and devices to electrical outlets, and then turn them on.
7 When a message appears stating that memory size has changed, press <F1> to continue.
8 Log on to your computer.
9 Right-click the My Computer icon, then click Properties.
10 Click the General tab.
11 To verify that the memory is installed correctly, check the amount of memory (RAM) listed.
Battery
Replacing the Battery
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in
"Safety, Environmental, and Ergonomic Instructions" on page 48.
2
1
2
1
Removing and Installing Parts
45
Advertisement
Table of Contents
