Table of Contents
Advertisement
CHEC K THE MOUSE SETTINGS —
Click the Start button, click Control Panel, and then click Printers and Other Hardware.
1
Click Mouse.
2
Try adjusting the settings.
3
Network Problems
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in
"Safety, Environmental, and Ergonomic Instructions" on page 48.
CHEC K THE NETWORK CABL E CONNECTOR — Ensure that the network cable is firmly inserted
into both the network connector on the back of the computer and the network port or device.
CHEC K THE NETWORK LIGHTS ON THE BACK OF THE COMP UTER — If the link integrity
light is off, that indicates no network communication exists. Replace the network cable. For a
description of network lights, see "Back View of the Computer" on page 12.
RESTART THE COMP UTER AND LO G ON TO THE NETWORK AGAIN
CHEC K Y OUR NETWORK S ETTINGS — Contact your network administrator or the person who set
up your network to verify that your network settings are correct and that the network is functioning.
Power Problems
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in
"Safety, Environmental, and Ergonomic Instructions" on page 48.
IF THE POWER LIGHT IS BL INK ING GR EEN — The computer is in standby mode. Press a key on
the keyboard, move the mouse, or press the power button to resume normal operation.
32
Solving Problems
Advertisement
Table of Contents
