Installation And Connection - Bosch HKS79R250A User Manual

Free standing cooker
Hide thumbs Also See for HKS79R250A:
Table of Contents

Advertisement

If the cooking time is relatively long, you can switch
the appliance off 10 minutes before the cooking time
ends.
¡ There will be enough residual heat to finish cooking
the dish.
Remove any accessories that are not being used from
the cooking compartment.
¡ Accessories that are not being used do not need to
be heated.
Allow frozen food to defrost before cooking.
¡ This saves the energy that would otherwise be re-
quired to defrost it.
Note:
The appliance requires:
¡ A maximum of 1 W when the appliance is in opera-
tion with the display switched on
¡ A maximum of 0.5 W when the appliance is in oper-
ation with the display switched off
Saving energy
If you follow these instructions, your appliance will use
less power.
Select the cooking zone to match the size of your
pan. Centre the cookware on the hob.
Use cookware whose base diameter is the same dia-
meter as the hotplate.
Tip: Cookware manufacturers often give the upper
diameter of the saucepan. It is often larger than the
base diameter.
¡ Unsuitable cookware or incompletely covered cook-
ing zones consume a lot of energy.
4  Installation and connection
You can find out where and how best to install your ap-
pliance here. You will also learn how to connect your
appliance to the power supply.
4.1 Electrical connection
The appliance must be connected to the mains by a li-
censed expert. You must comply with the requirements
of your electricity supplier.
¡ If the power cord of this appliance is damaged, it
must be replaced by the manufacturer, the manufac-
turer's Customer Service or a similarly qualified per-
son in order to prevent any risk.
¡ Any damage arising from the appliance being con-
nected incorrectly will invalidate the warranty.
Information on the electrical connection by the
installer:
¡ If the plug is not accessible following installation, an
all-pole isolating unit with a contact clearance of at
least 3 mm must be available on the installation
side. This is not necessary if the appliance is con-
nected via a plug that is accessible to the user.
¡ Electrical safety: The cooker corresponds to safety
class I and may only be used in conjunction with a
safety earth terminal.
¡ To connect the appliance, use H 05 VV-F cables or
other equivalent cables.
Cover saucepans with suitable lids.
¡ Cooking without a lid consumes considerably more
energy.
Lift lids as infrequently as possible.
¡ When you lift the lid, a lot of energy escapes.
Use a glass lid.
¡ You can see into the pan through a glass lid
without having to lift it.
Use pots and pans with flat bases.
¡ Uneven bases increase energy consumption.
Use cookware that is suitable for the quantity of food.
¡ Large items of cookware containing little food need
more energy to heat up.
Cook with only a little water.
¡ The more water that is contained in the cookware,
the more energy is required to heat it up.
Turn down to a lower power level early on.
¡ If you use an ongoing power level that is too high,
you will waste energy.
¡ Unused residual heat increases energy consump-
tion.
The mains voltage must correspond to the voltage
specified on the rating plate.
Connect the wires in the power cord according to the
colour coding:
Note: If the power cord is replaced Only connect it to
the appliance as shown in the connection diagram
¡ Green and yellow: earth wire  ​ ⁠ .
¡ Blue: (null) neutral wire
¡ Brown: phase (external conductor).
Important information about the electrical
connection
Note the following information and ensure that:
WARNING ‒ Risk of electric shock!
There is a risk of electric shock if you touch live com-
ponents.
Hold the mains plug with dry hands only.
Never pull out the mains plug from the socket while
the appliance is in operation.
Pull out the power cable directly at the plug and
never by pulling the power cable as this may be-
come damaged.
¡ Fit the mains plug and socket together.
¡ The mains plug can be accessed at all times.
¡ The cross section of the cable is sufficient.
¡ The mains cable is not kinked, crushed, modified or
severed.
Installation and connection en
7

Advertisement

Table of Contents
loading

Table of Contents