Electrical Connection; Connect Electric Range Cord - Bosch HGI8054 Series Installation Manual

Electrical Connection
The Dual Fuel slide in range may be connected using a
electric range cord (as specified in the Electrical
Requirements section preceeding) or using a flexible
conduit electrical connection. The Gas slide in range has a
120 volt power cord and plugs into a standard 120 volt wall
outlet.
Gas Ranges
The 120v power cord is installed on gas ranges.
Dual Fuel Ranges - Connect Electric
Range Cord
This section applies only to dual fuel ranges (does not
apply to gas ranges). Dual fuel ranges have a gas cooktop
and an electric oven.
,
Note: In Canada, the range is shipped from the factory
with the range cord already installed. Continue to
"Complete the installation" on page 11.For installations
other than those in Canada, connect the range cord at
the terminal block. Access the terminal block by
removing the cover in the lower left hand corner of the
range back panel.
Install Strain Relief
Place strain relief in knockout below terminal block.
WARNING
The strain relief provided with your range cord must
be properly installed.Strain reliefs vary. Carefully
read and follow the instructions included with your
strain relief.
1. In the knockout panel below the terminal block, remove
the knockout that fits our strain relief.
2. Feed range cord through hole and strain relief up to
terminal block. Allow for slack in the cord between the
strain relief and terminal block.
3. Once cord length/slack has been adjusted, attach
strain relief per instructions included with strain relief.
Tip: The knockout panel (below the terminal block) can be
removed from the range to install the strain relief: Remove
panel from range, install strain relief in panel and reattach.
DO NOT remove entire range back panel.
WARNING
Risk of Electric Shock or Fire. Frame grounded to
neutral through a ground strap. Grounding through
the neutral conductor is prohibited for new branch-
circuit installations (1996 NEC), mobile homes, and
recreational vehicles, or in an area where local
codes prohibit grounding through the neutral
conductor.
For installations where grounding through the neu-tral
conductor is prohibited, (a) disconnect the link from the
neutral, (b) use grounding terminal or lead to ground unit,
(c) connect neutral terminal to lead branch circuit neutral in
usual manner (when the appliance is to be connected by
means of a cord kit, use 4-conductor cord for this purpose.
Use only cord kits rated 125/250 volts (minimum), 30
amperes and labeled "For Use with Ranges". Strain relief
provided with cord must be installed per instructions
included with cord.
English 10