Installation
Before You Begin
Overview
Tools and Parts Needed
Additional Parts Needed For
Hard Wire Installations
Table 1: Overview
Step
Task
1.
Preparation
2.
Apply Foam Tape
3.
Install Backwall Trim (Optional)
4.
Connect Electric
5.
Connect Gas Supply
6.
Test for Gas Leaks
7.
Test the Installation
Proceed to the sections that follow for step-by-step instructions.
Range Power Supply Cord Kit (240V -30 Amp)
Note: Not necessary for Canadian installations; Canadian units are shipped
with the power cord already installed.
Measuring Tape
Phillips Head Screwdriver
1-1/4" (31.8 mm) Wrench
Pencil
T-20 Torx Screwdriver
Screws (2) and Anchors (2) for Anti-Tip Bracket (Style will vary depending on
mounting surface)
Level
Drill and Drill Bit
Soapy Water
Pipe Wrench
Teflon Tape
Channel Lock Pliers
Gas Leak Test Solution
Gas Supply Line
Gas Shut Off Valve
Safety Gloves and Goggles
Tape (Optional)
Cloth or Cardboard (Optional - to Protect Floor)
•
Flexible Conduit
•
Torque Wrench
•
Note: Power Supply Cord Kit Not Necessary For Hard Wire Installations
English 4