Table of Contents
Advertisement
Figure C-11. LCB Grounding
Figure C-12. Standard Grounding Connection
Step
Step
Step 10
C-16
3746-950: User's Guide
If you install an LCB onto a table or a floor, you must also install a
ground wire to ensure the connection. See Figure C-11 on page C-16
below.
To insure good grounding, it is recommended that you use the following
items:
AWG 12 wire (minimum 2.5 square millimeter).
5 mm diameter screw, length from 6 mm to 10 mm (see
Figure C-12).
Note: IBM does not provide these items.
8
Connect the LCBE cable to the LCBB. It does not matter which end of
the cable you use.
9
Tighten the retaining screws of the cable connector.
Label LIC11 cables with the two LIC11 labels (Part Number 63F2504).
Record the following information from the plugging sheets onto the
labels:
3746-950 name
LCB number
LCB location
Range of LIC11 addresses.
Advertisement
Table of Contents
